Following the success of our 'classic motorbike' collection, Ceramic Innovations are now offering an exciting new collectable series to build your own artistically licensed CHOPPER motorbike.

Over the next four years, around September/October each year, Ceramic Innovations will release a new piece in the series.

The series includes a Gas Tank, the Seat, the Frame and Carbie/Exhausts. When complete, the result will be a fully 3 Dimensional CHOPPER motorbike, approximately one metre long by half a metre high. Each decanter is filled with a Tawny Port.

The CHOPPER collection will be exclusively limited and individually numbered on the Frame.

Don't delay your subscription for the CHOPPER motorbike collectors series.

Approx cost for the series is about $600.00 over the four year period. You can start at any time until the last decanter is released (carbie/exhausts)

Our last concept collection the 'classic motorbike' was sold out!.

THE FRAME

The 2007 release of the Frame is the second of the four part CHOPPER collection. The Frame is 3 dimensional direct printed to brushed stainless steel. The Frame is designed to be wall mounted. The size is approx 1metre wide x .5 metres high. There are four layers. Firstly the matt black back board that under pins the unit. Layer 2, a high density foam, profile cut, that serves as the shelving to harness the decanters. Layer 3, Brushed Stainless Steel direct printed, that has been routered to the profile of each of the decanters. Middle section of the CHOPPER is direct print only. Layer 4, There are two sections, both are direct printed to stainless steel panel. The back wheel and then front wheel and forks are both block mounted, adding a further dimension. Our decanters Fuel Tank, Seat and Carbie/Exhaust all glossy and glazed typically simply slide into the unit finishing the Chopper to a realistic 3 dimensional work of art. On the top left hand corner of the panel, each Frame is numbered, confirming the limited edition.